Hand Bury Wire Length

Hand Bury Wire Length


  1. Use a garden edger to cut a narrow slit in the ground.

  2. Work in 6-inch sections at a time.

  3. Pry the slit open and push the wire in using pliers or wire strippers.

  4. Make the next cut so it connects with the previous one.

  5. Step on the soil to close the slit.

  6. Repeat until the wire is buried 2–3 inches deep.

    • Related Articles

    • Wire Break - Find & Repair DIY

      Wire Break - Find & Repair Video Link - https://youtu.be/Qiffv7XWTxk 1. Hook up tone generator ( see attachment) *Disconnect the two (wires) from the transmitter on the wall *Attach one alligator clip to one of the boundary wires *Ground the second ...

    • Training Flags - How to Place

      Take the Pet Stop receiver in one hand and the flags in the other hand Walk toward the boundary When the receiver (collar) beeps, you are at the edge of the signal field Place the flags about 6 inches inside the beep zone Position flags about 10ft ...

    • Plexidor Spring Replacement

      Please see the attached instructions on "how to replace the spring kit on your Plexidor." Here is a video link - https://youtu.be/bo7VXlNu4lk?si=AzuH6Yk4NlU3WESm

    • Program Ultra Tuff Receiver with an OT 200 Transmitter

      Below is a guide to programming your pet's receiver using an OT 200 transmitter. Video Link - https://youtu.be/JtTWcrV7I-g Programming: 1. Note the number that you see on the LED display of your transmitter (Mounted on the wall). Pro Tip - Also, you ...

    • Program Ecolite HO Receiver with an OT 200 Transmitter

      Below is a guide to programming your pet's receiver using an OT 200 transmitter. Video Link - https://youtu.be/JtTWcrV7I-g Programming: 1. Note the number that you see on the LED display of your transmitter (Mounted on the wall). Pro Tip - Also, you ...