Testing The Correction On A Dogtra Collar

To test the correction on a Dogtra collar, start by taking out the test light. 

Place the test light on the two contact posts securely.

Press the constant button (or nick button) and increase the strength of the correction via the rheostat dial.

As the strength increases, the test light will get brighter.

Alternatively, you can try it on your arm but this is not recommended. 

• Related Articles

• Dogtra Code Setting Guide

  When a customer buys a Dogtra additional receiver for their system or replace a lost transmitter they have to Code the units to work together Dogtra had all the Code Setting Guide on their Dogtra.com site https://www.dogtra.com/codesettingguides For ...

• Dogtra Batteries Not Holding A Charge As Long As They Used To

  In rare occasions a Dogtra product may stop holding a charge for as long as it did in the past. Sometimes this can be resolved by completely draining the batteries of both the receiver and the transmitter and then recharging them. This is possible on ...

• How To Program Ecolite HO Receiver with an OT 300 Transmitter

  Below is a guide to programming your pet's receiver using an OT 300 transmitter. Video Link - https://youtu.be/p3QTTmYXI0A Programming: 1. Note the number that you see on the LED display of your transmitter. 2. Put the OT 300 transmitter into ...

• How To Program Ultra Tuff Receiver with an OT 300 Transmitter

  Below is a guide to programming your pet's receiver using an OT 300 transmitter. Video Link - https://youtu.be/94wKLqkjIQg Programming: 1. Note the number that you see on the LED display of your transmitter. 2. Put the OT 300 transmitter into ...

• PDE - Pet has to get too close to activate door

  Problem: Pet has to get too close to activate door The Plexidor pet door should activate from 8 to 16 inches away. If your dog is having to get closer than 8 inches for the pet door to activate the door check the following: 1. Make sure there are no ...